I have a whirlpool TYPE: FCSM6, MODEL: AKZ451/IX/01, 2.3KW. It currently just says 'stop' on the clock display and does not do anything when i try and turn it on. the light inside the oven doesn't even turn on. There is still electricity getting to it as the clock works, any help would be appriciated, Thanks
Thanks everyone - and the power of the net!! Held Middle button in and turned lefthand dial - all sorted!!
PC1
January 2018
Hi,
My oven has had this problem for almost a week now. Today I tried everything on the Internet, Turning knobs off and on, switches the same but no response.
So in frustration I hit the counter top above the readout and low and behold the dashes came on. My luck must be in, I am off to buy a lottery ticket.
Joking apart
I hope you all manage to to get it working.
Allan Oxberry
September 2015
After oven has been on for a couple of minutes, it trips the main fuse
Can you help
Jim Clark
June 2015
"STOP" on front display
Set All dials to zero. Pressed middle button (ie adjust the clock).
Don't know if mine is the AKZ451. 8 year old single fan assisted Whirlpool.
Sorted it for me also.
Tks Spen
Neil
November 2013
I turned the oven off with the Red Isolator Switch on the wall, left it for 10 minutes, and switched it back on again, and all was well :)
Very strange though !!!
Russ Lecroy
February 2013
Had the same problem on my ANZ 161, could not reset and everone online was saying if you cannot reset it than, it could be a fault on the circuit board! A new board is around £120 to £160 to buy, I found that by just unplugging some of the connections to the circuit board and reconnecting it, fixed the problem.
tom
November 2011
4 yr old model with same 'stop' problem. Holding down middle button and repeated turning left dial resolved the error.
john
March 2010
I have this same oven/grill with the same problem.
It was new in the Barratts apartment four years ago.
I have just had a repair man round who says its the circuit board cost circa £100!
Rosiegirl
March 2010
Hold the middle button, push the first dial so it pops out, and do one full turn until it is back to "0" then push it back in and it should solve the problem!
If the above dont work, hold the middle button and turn the first dial in various combos etc, i just played around with it and it finally reset!
new
March 2009
Press the middle button (ie adjust the clock !!)
Sorted it for me.
Spen
September 2008
Set All The Dials to 0 then turn power off then on
biglad
September 2008
Automatic Answer
While you wait for answers, we may have found some information which could help you.
howtomendit.com for free repair help, information and advice.
