where to find ds lite p6 touch screen connector?

I think the Digikey part number FH19C-4S-0.5SH(25)CT-ND doesn't fit.
the molex BackFlip™ 501461 is a better choice

Ray
June 2012

its the smaller of the 2 ribbon connectors from the top screen
very easy th snap the clip if you do( like me) i used SNEWOS instructions and used a small piece of plastic cut to the same size and pushed it in on top of the ribbon cable to press down on the ribbon and make contact saves all the bother of trying to fit a new connector and works fine

devious010
June 2012

www.riparazioniconsole.net

The best
April 2010

ds doctor on ebay only £3.00 but takes a lot of patience to do it

jackie
March 2010

looked up ebay user ID ynysmon2007 cant find it got 2 that need p6 touch screen connectors on then

cum2terms
September 2009

For the DIY repair person (major soldering skill required), here's where to find the lowest cost P6 connector I've seen so far ($1 ea/$2 ship):

http://cgi.ebay.com/Touch-Screen-Connector-P6-For-Nintendo-DS-Lite-NDSL_W0QQitemZ380127336230QQcmdZViewItemQQimsxq20090528?IMSfp=TL0905281510005r36886

kingdaddyo
June 2009

Digikey charges $27,95 shipping costs for the connector ...Nice )o:

Massie
May 2009

Thanks snewo for the clear answer. I had the same problem but I've just made two sharp bents in the cable so that it stays in the connector while still having a little pressure downwards to make contact.
That worked fine for me.

John
May 2009

The ds lite touch screen connector is Digikey part number FH19C-4S-0.5SH(25)CT-ND. Im tired of people making ridiculous profits off these parts, so im gonna post part numbers everywhere i can.

linuxbatm
March 2009

I do it for £19.99 including return post in UK!!!
guarranteed for 90 days :-)

ebay user ID ynysmon2007

ynysmon2007
February 2009

look up ebay user ID ynysmon2007
sells them and installs them

Steve Davies
February 2009

Here's the deal, that little black connector is super fragile. I've broken 2 so far, one because I didn't know how to open it and one trying to move the black piece from a broken MoBo to a good one with a broken black thingy. I have a way to get your unit working, but keep in mind that it's a little ghetto.

Step 1: Find a stiff piece of thin plastic around your house somewhere. I used my plastic super market "bonus card" that fits on my keyring.

Step 2: Sharpen the plastic to a gradual point on one edge with sandpaper. I used a wheel grinder because it was easier.

Step 3: Cut a rectangle who's width is the same size as the ribbon cable that plugs into the connector. Make it long enough to be able to grab it with tweezers and manipulate it.

Step 4: Put it in the connector (thin side first) where the ribbon cable goes and make sure it can fit and goes in as far as the cable.

Step 5: put the ribbon cable into the connector and then place the plastic sliver ABOVE the ribbon cable but still inside the same connector. This puts enough pressure on the cable to help it make contact.

My unit is working now, I hope this helps you.

Snewo
November 2008