Scantronic 9448+ Reset?

That's the problem Alarm..... I cannot find the 'Molex Pins marked Reset'. I've had the board out and looked at every marking on it.

The circuit board has E88653(S) printed on it and also 105599*2 at the bottom under the Scantronic logo if this helps anyone?

GTS, thanks for you post but I already have the Engineers manual for the alarm.... Just have no idea where these damn pins are :o(

Thanks

Marc
September 2010

You hit bulls eye with that description, such a star.

Alarm
September 2010

alarm,the man aint playing darts,why not just give the answer to his question,power down the panel,mains and battery,open panel,locate the pins marked rst,they are near the microprocessor,place a screwdriver between them,with the blade across the pins,apply the battery,then the mains,the system will load the factory presets,thats 1234 for user code,the o7890 engineering code for the for the 9448 +its the same

gts
September 2010

They are the short pins with "RESET" written under them.

Imagine a dart board, hit trebble top, you missed the pins.
Now throw for a trebble 13 BINGOOOOOOOOOOOOOOO

Unless its the first panel, then you need to find the molex pins marked reset.

Alarm
September 2010