some models have 2 sensors to reset just push a pin in the back of the sensor (where the spades are) on the one which face is able to push in and out. It takes a bit of pressure and i had to wiggle it from the front at the same time.
Ant
May 2011
HI, just had the same problem , took the cover off to see , found the thermisters pressed with a pin , bang on ideal worked first time.
justin
December 2009
hi i was going to buy new element at £60 but saw this and tried it and it worked many thanks have a nice xmas
mick
November 2008
Reset button worked for me
Steve
November 2008
There is a reset. Remove the heater element cover and above the element you will see 3 round thermisters. One of these (an end one) has a small hole in the back. Press a pin into this and you shound hear a small click.
Job Done.
DaznJen
November 2008
no reset on this model need to replace them if need some email us
howtomendit.com for free repair help, information and advice.
