E10 coming on at rinse cycle 0n zanussiFJDR1266W?

The jetstream could be blocked but this will not cause an error code unless the pump fails.check the filter is clean as this reduces jetstream flow.E10 could be a faulty inlet valve coil (normally go open circuit).they should be around 3 to 4kohms if ok.Also check that the drain hose isn't pushed to far down the waste pipe if it is a freestanding one behind the machine.only put 8 to 10 inches of the drain hose down the waste pipe otherwise you can cause syphoning which will give an E10 error code

ck
April 2009