How do I fix my Zanussi washine machine FLS1183w??

Andy, having done the job, my advice is DONT. It's a b**** of a job to do and most likely the drum shaft will have wear on it where it meets the shaft/bearing seal. Even when you fit the new shaft/bearing seal, a slight weep of water will still occur into the bearing set. Most likely, as in my case, it will last a month or two and let go again. It's not worth while buying a new drum shaft assembly, as it is expensive. In my opinion, its cheaper and will cause less heartache to go buy a new washing machine.

Tony
October 2005

Replacing the bearing components inside one of these machines is a task even experienced zanussi engineers wish to avoid. Done properly by yourself the parts you will need are a rear drum, (possibly a drum front if it's got that bad), inner drum, a drum seal, and I always replace the element. additionally you may want to include a couple of band-aids.

Not replacing all components will probably result in the same problem in a couple of months time.

retail parts cost at well over £100, I'd take a trip to Comet.

Paul
August 2004

Hi Andy

I am also looking for an answer for the same problem that my Zanussi machine is suffering with.

Have you got any luck with this one yet?

I am sick and tired of visiting Launderette :-(

Cheers!

Michael

Michael Gill
July 2004