How can I reset my Mira Advance shower?

What do I have to do to reset Mira shower the 2 red lights are on

JUBILEE PLACE
November 2018

My power button is flashing and the shower keesd turning it self off and on

sam
December 2014

this shower has a built in temperature sensor its a safety feature which will cut the shower off if it believes it is too hot follow the reset instructions in the guide basically have the water at its lowest temperature to start with and gradually raise it up you can find all you need to know here
http://help.tradingdepot.co.uk/wp-content/uploads/2013/09/mira-advance-9kw-user.pdf

andy
February 2014

how do i set mira advance

staffiesam
February 2013

Where is Christine answer???????????????

Ade
March 2011

Any other suggestions - was it the high power you pressed - is there a reset button anywhere on the Advanced model

Martin
June 2010

I need to reset the above shower, It wil run when it is cold but resets when I turn the temperature up! Any IDEAS?

Keith
June 2010

thanks for the answer christine, worked perfectly
Gino XXX

Gino
November 2009

Ity worked for me too thx

christine x
May 2009

i had same problem. but wait about 5 or 10 minutes, hold power button in and pull main power cord on. It worked for me. ( i know it sounds back to front but it worked). Good luck, Andy

Andy
June 2008

will do if you have a low water supply.

hi-spec plumbing & heating
June 2008