I am having problems with my ultima 1200(about 7 yrs old). Last week out of the blue it stopped just as it had filled up with water, and refused to do anything other than peep and display this message. I replaced the bushes which were quite worn and it went ok for a week. One week on it's doing it again filling up with water then nothing apart from the peep and E30 display. I have had the motor checked and it is fine any ideas please
I had the same problem luckily the machine was still under warranty.
if i remember right they had to put a new water pump in.
Gary
May 2005
I have the same problem with my hotpoint ultima 1200. I checked the pump for obstructions and found none. I would usually cancel the program and turn off the machines for about an hour and try again later. Sometimes it would run ok but the fault is coming back most of the time. If you find the solution would you kindly share it to me? Thanks
howtomendit.com for free repair help, information and advice.
