change bulb on front turn signal 1993 plymouth voyager?

Thank you Fred. You were exactly right on finding the 3 T-20 head bolts. I would have never been able to figure out how to get the lense off. I was able to use an allen wrench to do the job. The t-20 bolt in the grille was a little tough but it just needed a little liquid wrench first.

Rob
April 2009

Open the hood and prop it up. In the very front corner of the exposed area is a Torx T-20 head bolt, not really recessed, but in a hole in the cosmetic treatment. Loosen and remove it. It takes quite a few turns and it's unusually long.

Look to the inside of the turn signal lens, within the grille, for a similar T-20 holding a tab, loosen and remove.

On the outside of the vehicle, between the turn signal lens and the headlight housing is another T-20 screw.

With all three removed, the lens assembly slides slightly outward, and then slightly forward for access to the bulbs. Turn each bulb a quarter turn counter clockwise (unless you're viewing a digital clock) and they release.

I discovered that my bulb was not blown, and only needed to be removed and replaced to "wipe" the contacts and work again.

Reverse the above steps to re-install.

fred
April 2007