How can I fix Qualcast hedge trimmer?

Hedgemaster 380 works intermittently. Brushes not worn. Commutator ok. Works when held vertically stops when lowered to horizontal

Rice

July 2012

There is more help available. Mend - qualcast, hedge, trimmer
Need to mend your Qualcast hedge trimmer?

Check cable, hold so that it runs, and move the cable, as if you had moved the unit. But keep unit still, if it cuts out, damaged cable, the bad section would need to be cut out, and them reattached inside, If not cable, possibly a contact inside SD July 2012

Add An Answer Form

Add your answer using the form below ...

Other questions in this category - Garden Tools, Hedge Trimmers

How can I replace the cable on my Qualcast hedge trimmer?

How can I replace the cord on my 600W Qualcast hedge trimmer as I have accidentally sheared through this last week. Is this expensive and should I cut my losses and invest in a new trimmer? Perhaps you may know if there are any people who repair these in the North East. Thanks...

Click here for the fix.
Does the gear section need grease or lubricating?

I have a Qualcast HTEG 55A corded hedge trimmer, , the blades spin, but do not cut the hedge. I have removed the plastic cover at the base of the handle- cleaned out the grease and leaves etc. What lubricant should be used for the gearing if any?...

Click here for the fix.
Replaced drive belt ?

Replaced drive belt on qualcast 380 hedge trimmer but it keeps slipping off and cutting into housing...

Click here for the fix.
how can i repair my pullstart please?

hi i have a qualcast petrol hedgetrimmer slk26a and the pull start assembly was broken and an attempt at repair by previous owner has left it with no springs attached but i do have them.please advise me as to how i reinstall them as im having great difficulty doing so.many thanks.mark.....

Click here for the fix.
How remove case on Qualcast 600w hedge trimmer?

Yep you guessed it .... cut the cable :-( Need to get inside case for proper repair. Cannot get it apart ... removed 5 obvious screws plus handle and 1 screw under handle but case will still not separate at blade end. Anyone know what is stopping it and how to get it apart please?...

Click here for the repair.
I have a Qulacast Hedge trimmer which runs but the blades are loose.?

I have a Qualcast Hedge Trimmer which normally is great. Now though, the blades have come loose and it does not cut. I have tried tightening the bolts on the blade but that does not work. is there somewhere else I need to check? thanks...

Click here for the repair.
steel arm on qualcast diagram?

where does the metal strip locate on Qualcast switch box...

Click here for the fix.
rewiring a qualcast hedge trimmer 380 ?

After cutting the wire whilst hedge cutting, I rewired the black and brown wires into the junction box back according to instructions. It still doesn't work and feel I may have joggled the wires at the back of the black connection box but can't get into it easily to see. Any suggestions....

Click here for how to mend it.

			Ask for free help
:: home :: add a question :: search		:: help :: most recent :: unanswered
	Search: Go

How can I fix Qualcast hedge trimmer?

Hedgemaster 380 works intermittently. Brushes not worn. Commutator ok. Works when held vertically stops when lowered to horizontal

There is more help available. Mend - qualcast, hedge, trimmer Need to mend your Qualcast hedge trimmer?

There is more help available. Mend - qualcast, hedge, trimmer
Need to mend your Qualcast hedge trimmer?