Next step is to pull up the two buttons for steam and water spray. You got two screws under them. Another screw is under the cap that close the water intake.
After those you can remove the top handle of iron.
Then you got another few screws but you can find them easily. Remember you got extra two screws under the temperature control knob (you need to pull it up as well). Then its really easy to change cable (you can use old cable connectors).
By the way, this iron got really bad quality power cable and russell hobbs should be taken to court for risking people life.
Quanhi September 2016
Cut Through the top forward of the cable entry nothing inside remove back screw , you cannot get at the terminals so cut the existing cable long enough to attach a heatproof connector,make off your new cable,replace backplate the screw does hold it place,bingo
Parkspark February 2015
They do not make them to be repairable - to get to the place you seek you will need to destroy the iron. Probably best you give up and invest in a new one.
Same issue as Debbie?Continuous steaming from the Russell Hobbs Steamglide Iron from plug in until reservoir tank runs dry....Click here for the fix.
how to replace the flex on russell hobbs 12379?Can anyone tell me ho i replace the flex on my russell hobbs iron model no 12379...Click here for how to mend it.
Filter Russell Hobbs 14721?Where can I get new filters from for the Russell Hobbs 14721 steam iron please?...Click here for the repair.
russell hobbs fitlers model 20392?I have been trying to get water cartridge for my russell hobbs
smartglide steam genarator the model is 20392 please could you help....Click here for the repair.
Fix Russell Hobbs steamiron?I need to open up my Russell Hobbs steam iron - model RH1102 but have no idea on how to dismantle the iron as it has no visible screws or anything else to open it. Please help.
Thanks...Click here for the repair.
How can I check the element in sole plate?Russell Hobbs steam glide Model15131
Power reaches the terminal block in rear, but light does not work when temperature control is turned on, hence no heat. Has the element burnt out?...Click here for the fix.
OPening Russell Hobbs Turbopro 1400 iron?How do I open my Russell Hobbs Turbopro 1400 steam iron...Click here for the fix.
Steam Iron not working?I also left my Russell Hobbs Steam Glide on all night and now is not working. Changed fuse but not rectified. Where do I go from here?...Click here for the fix.
repairs can be dangerous.
In many instances work should only be undertaken by a qualified
professional. Ensure you have read our Small
Print page before using information supplied via this website.