Hello
After removing wheel there is no access to bearing hub as it is set back into the surrounding casting. No bolt holes for fixing pulling tools .
How do I access the bearings.
Was hoping it was the old system when you pop off the domed cover to access the castle nut / split pin and remove.
Looking like have to have the whole unit removed with special tools?
Thanks CDC.
I was hoping that was the way.
L D V. Love them.
The manufacturers got many things wrong but so many other things right.
Wunderstuff
February 2017
Used to use a long tyre lever to remove hub cap, some are tight but they usually move,split pin and 15/16" nut, tapered roller bearings and there are notches in hub to knock out each bearing race, good luck.
cdc
February 2017
Automatic Answer
We may have found other answers which could help you.
howtomendit.com for free repair help, information and advice.
