Hi there I have an c&k securitech 700L alarm, I've recently started getting a tamper fault that comes and goes and sounds from the keypad until I reset it.
I've tested the battery and that's okay, and put a link across the 24hr tamper which I assumed would stop any tampers but it still it says I have one. I can reset the alarm and the tamper goes and will be okay for a day or so but will come back and is becoming quite annoying.
I have also done a continuity test on th tamper circuit and it bells out okay??
Tom, how did you test the battery and what was the result?
AA
February 2017
External sounder also has a tamper loop. Most likely sounder cover slack not fully closing tamper switch.
(depending on sounder make)
Insert loop in terminals R and - in control panel (adjacent to Bell + and -). If no further activations get out ladder and check sounder fixings/wiring.
Alan
February 2017
Automatic Answer
We may have found other answers which could help you.
howtomendit.com for free repair help, information and advice.
