The poster said they can turn the dial on by hand and it then drains and spins. If pressure sensor was blocked it would over fill. Pump is not blocked as poster states. Poster did not come back to advise if he followed my suggestion in previous post i.e. check the drip dry switch is on normal. If it is not then machine will stop and not drain or do final spin. He may get a better result if he answered the first suggestion instead of starting a new post.
Lincoln Appliance NZ June 2018
could be the pipe from the bottom of drum up to the pressure switch is blocked, it tells the machine how full/empty the drum is of water. remove machine top cover to see it connected to the sensor switch somewhere behind the front panel at the top. Or blocked pump filter or load too heavy.
Door latch on hoover nextra optima washing machie ?Can someone tell me how to change the latch on a hoover nextra optima..this thing has caused me to explode, wish i had taken a picture first but didnt expect it to be like this...Click here for the repair.
How to Fix Hoover elite 930?How to Fix Hoover elite 930
It isn’t draining and spinning to finish the wash cycle
Though I can reset the dial at place to drain and spin manually...Click here for the repair.
my washing machine wont spin or empty?hoover hd244
the program stop after initial filling and a few rinses then it stops and the start delay light flashes. I have tried cancelling the program and resetting nut it does it every time....Click here for the fix.
No water coming into machine?Just got a s/h Hoover classica which I understands was working daily before it came to me, plumbed it in makes usual sounds but no water coming into drum, it's just on cold water feed is it a hot and cold machine and therefore not wanting to work ?...Click here for the fix.
hoover 200m 4.5kg heavy duty washing machine overflows onto floor when fill?my hoover 200m is about 20 years old its a top loaderand now the water does not shut off when filling the machine at the beginning of a wash cycle.it has over flowed out of the top and over the floor I found a bit of flat metal bent like a lever?on the floor under the washing machine,shaped like an...Click here for how to mend it.
repairs can be dangerous.
In many instances work should only be undertaken by a qualified
professional. Ensure you have read our Small
Print page before using information supplied via this website.