Looking for information on adjusting the clutch on a JOHN DEERE 4300?My tractor jerks in all forward gears when I let out
the clutch. This doesn't happen in reverse. The clutch is almost all the way out before moving. My tractor is a 1997 or 98 John Deere 4300 4wd with
sync reverse. I'm hoping to be ablt to fix this without going to a dealer....Click here for how to mend it.
john deere ls115 series 100 fuel pump is leaking ?leaks from the gold colored screen on the side have replaced pump but problem persist...Click here for how to mend it.
Can't get John Deere STX38 to start?My John Deere STX38 won't start. It doesn't make any noise at all when I turn the key. The battery is good. The cable to the positive end was very corroded, so I cut it off and put a crimp-on copper end onto the cable as temporary repair. I also disengaged the seat cutoff switch just in case it ...Click here for the fix.
Tractor won't start after being shut off in gear?Our John Deere 2005 5103 Tractor was shut off while still in gear, and now it won't start....we've checked the battery, tapped on the solenoid, but nothing is happening. What else should we check?...Click here for how to mend it.
I have a John Deere sit on tractor mower 14/30 8/GS and I have purchased a ?new drive belt unfortunatley i have mislaid my manual,have you a diagram/drawing showing which way that they fit on the pullys and any other advice when fitting please....Click here for the repair.
engine dies out?have a john deere 720 3 cyl desiel it starts right up but dies out after 30 seconds is gettig fuel to injectors but wont power up just dies out could it be a bad or clogged injector....Click here for how to mend it.
John Deere tractor-how to get the tie rod loose ?I need to replace torn grease seal on tie rod on Mod 4710 FWD JD tractor (2002) I removed the nut, the shaft will not slide up....Click here for how to mend it.
John Deere 2040s pick up hitch ?Pick up hitch will not lift sufficiently to disengage the lock.
Is there any adjustment / setting up that can be done? Or am I doing something wrong?...Click here for the fix.
repairs can be dangerous.
In many instances work should only be undertaken by a qualified
professional. Ensure you have read our Small
Print page before using information supplied via this website.