Tapper light on unable to reset.Key pad dead
What I have done :- Repaced The Battery Tried to reset it .
( Reboot )Power off /disconnect battery/ reconnect batt,box door shut / mains power on..It allows me me to enter the factory code 0123 alarm stops the key pads go dead. Tapper light on & Mains light..
Any advise would be appreciated
No green light in optima XM burglar alarm?Though I put new battery and fuses,no green light.Why?...Click here for the fix.
Unable to set Optima alarm?I am unable to set my alarm. The control panel lights look normal but when I enter my code, the beeps are normal but nothing happens. I tried to go into programming mode but again it just returns to day mode. I tried switching off the mains voltage and the alarm sounded outside, but when I powered u...Click here for the repair.
Optima plus 2 small keypad?I have two keypads one on the main box and one by the front door. I had my power turned off for 30mins whilst a repair was being made on electrical socket. Since turning the power back on the small key pad won't work it just shows a red tamper light and no power or day light. Keyboard does not work....Click here for how to mend it.
Program my 8EP396A optima compact alarm?What are the exact sequence of buttons that i need to press on the control panel to program a zone for entry/exit and to time for 20 seconds?...Click here for how to mend it.
I have optima optima xm alarm plus panic alarm unit operated by red plastic?Have optima optima xm alarm system also panic alarm unit which operates with red plastic key can this be replaced as I've lost mine thankyou...Click here for the repair.
Optima XM Alarm panel dead?I was replacing two light switches. Turned of power to them. Only after job was done did I notice numerous LEDs lit up on my Optima alarm panel. Pressed reset but nothing happened. Tried to enter pin code but no response from buttons. In fact no buttons respond - completely dead. Power light is on (...Click here for the repair.
How can I fix my optima 2 alarm?I have an optima 2 plus alarm the main box is upstairs with a keypad downstairs. The power red light is flashing and beeping every three seconds on the ķeypad this happened following an interruption in the electricity supply. It will not reset and none of the keys work on either panel. Can anyone ...Click here for how to mend it.
optima xm 4 zone?i am wanting to change my entry and exit time i press prog all leds light up i enter code day and tamper light up then i press prog 9999 and the alarm won't go into engineer mode.the alarm is about 5 years old....Click here for how to mend it.
repairs can be dangerous.
In many instances work should only be undertaken by a qualified
professional. Ensure you have read our Small
Print page before using information supplied via this website.