BAD POOL CALLER?

Reboot system
update chip set to macro/56 specifications
update all system drives
disconnect internet
divert all .sll trafic through the ethernet filter

charlie
March 2009

1 step: reboot your pc
2.step: reset your DROM
3.step:save mood
4.step:run CMD
5.step: systm, config bsod
6. step: save as my com., local disk;(c), temp, system
7. step: rebbot your Pc

abc
November 2008

Try removing any PCI/ISA cards that you don't need for install (except video card of course) and then do the install again. If it does not fail, start adding cards after install until you receive the message again. Once you get the message, replace the last card installed.

BrokerTechs
May 2007

removd the modem and try lkgc

Prashant Mishra
March 2007

removed the modem and try lkgc

Prashant Mishra
March 2007

I ran across the same problem when installing Windows XP Professional on a Pentium III 933Mhz machine that I was working on. I tried unsuccessfully for days to get the operating system to install, but it would stop at about 80% with the same errors you mentioned. (I had 768 MB of ram in the machine at the time.) I eventually figured out that one of the sticks of ram was bad. I removed that stick of ram and Windows installed perfectly and has been running fine since.

You can download the memory diagnostic test from Microsoft at
http://oca.microsoft.com/en/windiag.asp Be sure to read the instructions.

P.S. You may also want to consider increasing your ram to 512k. I believe you would be much happier with the performance of your machine. I personally find that Windows XP runs a bit sluggish on 256 MB, especially once you install all of your other software and have multiple things running.

Good Luck!

T. Michel
May 2005