Countax C600H lawn tractor - melting fuses but not blowing?
My Countax C600H lawn tractor keeps melting the fuses, but not blowing them. I have checked the brake switch and the seat switch which is where the manual suggests to check. These are both fine. The charging system is also fine. Has anyone any suggestions as to what the solution might be.
I suspect you need to change the fuse holder. Sounds like it has gone HR and is therefore causing a voltage drop and heating up. If you take the fuse out and look into the holder slot it will look dark and corroded. It should be clean or you will get a bad contact.
Mick J.
October 2012
My brake rod has snapped on my Countax c600H sit & Ride mower and I cannot find a repalcement part anywhere on the internet
Greg Spence
June 2012
im having same problem ,mine is a countax c800 he and the wires have been getting hot and melting fuses,been trying to find problem ,bypassed switches ,still the same have pulled the fuse for the he extras ,deck lift and collector lift and the heating problem as gone but no power to deck ,and collector any ideas guys.
wayne.
April 2012
I have the same problem with melting fuses and I believe it to be the solenoid at fault. The solenoid clicks but does not engage. Prior to this the engine would sometimes struggle to be turned over by the starter at ignition. I will try to post the resolution when I get there.
Daniel
July 2009
usualy a bad connection will cause heat and not blow the fuse
bg
June 2008
I don't really see why the interlock switches would cause fuses to blow...however I have had this problem with a Mountfield tractor, similar in size to the Countax (is yours the one with the splendid Honda V twin)? Anyway this machine would pop the fuse every time I wanted to start up - the cause was a faulty starter solenoid.
John
April 2008
Automatic Answer
We may have found other answers which could help you.
howtomendit.com for free repair help, information and advice.
