4 hours ago: Toyota overlocker model 3400 D?

Mend Nissan Primera Cars

Mend Vehicles, Cars
Find out how to mend it for free.

Ask Question
Mend Vehicles, Cars
Click here to mend Nissan Primera cars

Mend > Cars

Mend Vehicles, Cars

indicator fault on nissan primera?

When I am indicating mainly on the left indicator my 2003 nissan primera 1.8 SE starts hesitating, and appears to run lumpy, this goes when indicator goes off.

Susan
August 2008
I have a fault reading PO335 crankshaft circuit problem. Loss of power and using too much fuel any ideas? Thanks

Col
April 2014
I know that this is the wrong attitude, but I removed the fog light bulb to stop the problem short term and it has worked. To do this, you need a ph screwdriver and a 10mm socket & ratchet to remove the cluster. Whilst you're under there, give it all a good going over with WD40 for good measure and replace any other blown bulbs.

Obviously plan to fix it properly and when I have some spare time during daylight hours, I will be trying this fix (courtesy of NPOC: http://www.npoc.co.uk/forum/p12-rear-light-removal-now-with-simple-earth-fix_topic16533.html).

Harry
January 2013
I had this fault too,only it was caused by the signal unit wired in for my trailer bar indicators that i used for carrying bikes.I took it of as i now use a roof rack and the problem dissappeared.

Derek
November 2012
2004 primera t-spec 2.2 dci Primera. Indicator and break light issue - fault appears to be corrosion on the connector terminals on the rear O/S light cluster, all was ok with indicators until breaking, then the lights all went daft with the fog light indicator on the dash board glowing dimly and the O/S indicator went out and the O/S break light starts to flash very quickly.
Cleaned up the spade terminal on the light board and the spade connector in the terminal block. all is OK now but you only have to wriggle the connector block out slightly and the fault re-appears, so I don't think it will be long before the fault re-occurs, I think the real fix will be a new cluster light board and connector block as I think the corrossion has gone too far. IT SEEMS THAT A BAD CONNECTION OR EVEN FAULTY BULBS CAN CAUSE ALL SORTS OF ISSUES WITH CAR ELECTRICS

Steve S
August 2011
thank you everyone for your answers it was corrosion on the spade connectors into the light cluster

susan
May 2011
nissan primera 2003 1.8 hi guys welcome to club, i have the same problem. went to nissan center they charge me 600 eiros to find a problem (a.. h...!!!) but after 6 month its starts agen,problems with electrics Problem starts with ABS and Seatbelt dash lights coming on. Radio then goes off and then all speed , rev , fuel dials etc go to zero. Car continues on for a couple of miles then begins to lose the power and then cuts out. i will try to fix it today and then i will tel u where thr problem was!!!

mad nissan owner
April 2010
I had the same problem 2 yrs ago on my 03 1.8s Primera. I removed the o/s rear light cluster and cleaned up the connections and all was well until a couple of weeks ago. The same car developed a problem with the central locking system. The car for no reason would unlock itself??? Not at regular intervals either day or night the doors would unlock. I went to the original problem (O/S REAR LIGHT CLUSTER) and found that the connections were all black and dirty again so cleaned it up and hope that all is well again. While I was undoing the connector from the lights, the car was going crazy unlocking all the time so I can only guess that this was the problem (A BAD EARTH)? It didn't unlock once after I cleaned things up and put it all back together again.

Andy
June 2009
I have a very similar problem. Apparently Nissan have the bulb casing as stores as they continually go. I had it replaced last year for the indicator issue and need it replaced again because of the break light fault.

Marie
May 2009
This is a common earthing fault in the rear light cluster. Clean all the contacts in the rear bulbs and replace. Strange as it may seem problem should be fixed.

primeradriver
March 2009
common fault on these and it is the rear harness connectors for the lights. the have high resistance and will need new ones

adam
March 2009
Just had a similar problem when indicating right. It also cut out the cruise control and dashboard lighting amongst others. It turned out to be an earthing problem and needed one of the rear bulb holder's replaceing.

All seems to be OK now

Bob
March 2009
I have exactly the same problem. The car is going into a Nissan main dealer to be looked at soon and I'll let you know what they say.

Experience tells me that they'll have absolutely no idea what the problem is though and will simply change things (and charge me for them) until they fix the problem...... so if anyone has any ideas where the problem lies I'd like to know.

Dave
October 2008
Mend Vehicles, Cars
Click here to mend Nissan Primera cars

How to mend ...

Find out how to mend just about anything howtomendit.com for free repair help, information and advice.
Mend Vehicles, Cars
Click here to mend Nissan Primera cars