remove wheel,slacken t/rod end lock nut and remove nut from balljoint,shock the balljoint from its taper with 2lb hammer,count turns when removing and screw on new end same amount of turns and tighten all nuts,check other side lock nut is free and adjust wheel alignment when complete,you will need the special guages to do this good luck
wickham
July 2010
i use a haynes manual as i find the pictures useful,as opposed to a list of instructions, so as to make sure i am doing job correctly they are about £15-£17 or look on car boot sales
Bill S.
July 2010
I can answer this question...
List the procedure you used for replacing the track rod end?