How to mend Kenwood Kenwood

3

How can I fix slow speed on Kenwood a701a?

I recently replaced the 450 ohm resistor on kenwood chef a701a. the motor is now running but only on no load, ... [Read more]

1

How to replace brushes on Kenwood Chef A901?

How does one open up the Kenwood Chef A901 so that one can replace the brushes?

1

450 ohm resistor on Kenwood chef A701A?

I am suspecting that the 450 ohm resistor is faulty. It is giving open circuit. I found a replacement on ebay... [Read more]

1

How do I strip a Kenwood Model KM210 Mixer?

How do I strip a Kenwood Mixer model KM210?

KMXC560 how to replace small pully & tension bar?

I have to replace the small pully and tension pin on my Kenwood Chef KMC560 I tried to use the liquidiser when... [Read more]

Sourcing a replacement shaft for a FP505?

The plastic on the shaft has split making accessories and tools difficult to insert and remove. I cant find a ... [Read more]

How do I dismantle Kenwood FP310 blender?

Inadvertently left Kenwood FP320 on live electric cooker element and burnt bottom panel. Now have replacement ... [Read more]

1

im trying to fix a kenwood chef mixer a703c ,motor goes gearbox seems to wo?

i have the kenwood a703c the dog clutch doesnt seem to wind right down on top of the large plastic gear .

1

kenwood mixer smoking?

My Kenwood mixer started to smoke Bradley while mixing,what could it be and how much would it cost to get repa... [Read more]

1

Kenwood Smoothie 2 GO just cut out?

Why has my Kenwood Smoothie 2 GO just cut out mid mix

2

kenwood chef A701 kitchen mixer?

Motor runs OK speed control works OK, until the motor is put under increased load and it cannot cope, checked ... [Read more]

1

what to clean gearbox of mixer with?

have a Kenwood chef a901e mixer and I am replacing broken gears. I need to clean housing can I use petrol to d... [Read more]

What do I do with the 6th wire when replacing new motor ?

Kenwood mixer FP520. " speed motors have 5 wires the 3 speed motor has a 6th wire what do I do with the extra ... [Read more]

1

Kenwood A901P changing speed controller?

Hi Because a capacitor had burnt out on this mixer I purchased a replacement speed controller board from espa... [Read more]

How can I open top part of a Kenwood MX270 mixer?

I need to change speed controller of my MX270 mixer because speed is inconsistent while working. How can I se... [Read more]

How do I remove the white plastic cover on my K C a901 ?

The white plastic cover on my Kenwood Chef a901 will not release at the black nameplate end, so I can't get th... [Read more]

2

I need a pinion drive gear complet with clutch dog nut?

I have Kenwood chef model A701A it is not working because driving pinion dog nut thread are gone. I want to bu... [Read more]

1

kenwood 901E motor not running smoothly?

how do I fix my 901 motor and stop it "hunting". the motor doesn't run smoothly particularly at slow speed

kenwood chef dial turning around continuously?

My Kenwood Chef (KM201) won't start. It's not a motor problem but rather seems that the on/off/speed dial, is ... [Read more]

1

how can i fix my kenwood blender?

my kenwood blender it produce smoke and it is very slow,what the problem could be?