How to mend...Gbc 4250

GBC 4250 Blows 1A 250V SloBlo under right cover?

This machine was gifted to my church from a local school. They said they took it to a repair shop to get it f... [Read more]

What is the temperature rating for the thermal fuse on a gbc4250 laminator?

What is the temperature rating for the thermal fuse on a gbc 4250 laminator

GBC 4250 No Power?

What happened: Co-worker went to use the rear cutting blade to cut off excess laminate while the machine was ... [Read more]

Lost power while running and will not power back on, help!?

GBC-4250 - Lost power while running and will not turn back on. I tried a new power strip and replacing the fus... [Read more]

GBC 4250, runs backward with mode select switch in off?

When operating the machine and putting the mode select switch in the off position, the rolls turn backward ins... [Read more]

Model GBC 4250 laminator drive chain is loose?

How do I adjust the drive chain on our GBC 4250 laminator? I have replaced the two gears and the chain. Ther... [Read more]

How can I repair a GBC 4250 Laminator?

I'm a teacher who is pretty handy. I've already fixed a few problems with this laminator before but now I'm s... [Read more]

GBC 4250 Laminator - overheated (thermal switch / transistor)?

Our school has a GBC 4250 Laminator. It went dead while it was operating. From the posts I have seen this in... [Read more]

4250 GBC Laminator?

We are going to all cold lamination...is there an easy way to turn off the heaters on the 4250?

how do i clean my rollers on my gbc 4250 laminator?

I am trying to get my gbc laminator to work. The laminator takes a very long time to heat up.

Schematic to reconnect circuit board on GBC 4250?

The side compartment of our GBC 4250 laminator fell off and the wires became disconnected from the circuit boa... [Read more]

GBC 4250 with Heat at all?

Hi there, I have a GBC4250 Laminator that I purchased used and it has no heat at all, I did replace thermal se... [Read more]

gcb 4250 overheated, calling Bob Haller please?

I started searching for info on troubleshooting a GBC 4250 and came across a few posts on here so I'm hoping B... [Read more]

GBC 4250 laminator does not turn on?

Have troubleshot. Had laminate roll around exit rolls; didn't know about reverse button (no manual); turned of... [Read more]

GBC 4250 Laminator won't heat?

The power is good. The lid cutoff switch works. The Thermal cutoff is on (not cutoff). The heat sensor reads 4... [Read more]

gbc 4250 blows fuse?

i have a gbc 4250 laminator it heats up fine it worked yesterday today when i went to use it and turn on the ... [Read more]

GBC 4250 Laminator....dead?

We have a GBC 4250 Laminator that seems to be completely dead....the fuse is good, so we are trying to figure ... [Read more]

Our GBC 4250 laminator does not reverse ?

We have an excessive wrap-up of film and need to reverse to correct. Reverse does not work. thank you!