When I push the long hair trimmer up, it slips out of alignment and doesn't cut
Gar March 2012
I have this model and it stopped working on me. Turns out it just needed a cleaning and oiling since it was jammed up with hair bits.
Try removing the trimmer completely and sliding it back in. You do this by first removing the blade cover at the top of the electric razor since otherwise it gets in the way. Then push the trimmer up and keep pushing until it slides right out. Examine it closely for any broken parts, clean out all hair and debris, and slide it back in. You have to line up the back of the trimmer at the right spot to slide it into the tracks. If it is broken and you can't fix it, there are at least two online retailers as of April 2016 that were selling the trimmer piece at only $9-10. Do an internet search for it and you should find it. Good luck!
How do I get my t85a apart?I need to get the screws out to try to repair it they are not normal screws...Click here for the fix.
How to replace battery to a Braun silk epil lady shaver?Braun silk epil 7 lady shaver won't charge. Any suggestions?...Click here for the fix.
whcih particular battery is required to change for my philishave 5885?i need to change the rechrgeable battery for my shaver -philishave 5885. Which specific battery i would need and where can i buy it?...Click here for how to mend it.
I cannot find any tabs or screws in order to open my Braun 5550 razor. The ?Razor is dead. No one can open it....Click here for the fix.
How to replace Braun Trimmer in Series 7 790cc?Hi - I was too ham fisted extending the trimmer on my Braun 7 series shaver - 790cc. The result was that the trimmer was over extended and popped out of its guides and now totally loose. The bottom spring seems to be ok as well as the plastic parts, but I can't seem to find a way to get it back into...Click here for how to mend it.
R1 Resistor for philishave model 920?need the value of r1 resistor for the charging PCB of my philips shaver. It's burnt out and need replacement
thanks...Click here for the fix.
shaver light and plug?the strip light bulb was replaced but was intermittant and finally refused to light although the shaver plug functions normally. the bulb is attached to the cover and the contacts at each end push into the base unit. This is a MK shaver appliance. with no other details model etc., it has a 230v 115v...Click here for the fix.
repairs can be dangerous.
In many instances work should only be undertaken by a qualified
professional. Ensure you have read our Small
Print page before using information supplied via this website.