DAEWOO LANOS 1.6 SX CYLINDER HEAD TORQUE SETTING?

hi wat is the cylinder head bolt torque settings on a daewoo lanos 1.6 16 v 2000 model


marius
January 2022

thank you nigel, i have been searching everywere for these torque settings. thanx alot.

james
June 2012

in let and exhaust manifold on 25NM head bolts on 25NM-60deg then slakenof indiviguly half a turn tighten on 60 deg run engine wait slaken of induvigely half a turn tighten on 60deg and run engine wait slaken of half a turn and tighten on 10deg

kks cawboy
February 2011

also the block will need the crank sensor on the crank pulley like the vauxhalls

beck motors
January 2011

I have a Daewoo Tacuma 1.6 SX. I have been told the cylinder head is the same as the Lanos, si I guess the sequence is the same too. The question is, how are the bolts numbered (looking at engine in situ) top row, middle 2 hex bolts, bottom (or closest to front / Exhaust manifold) row ?

i.e.

Inlet manifold
---------------------
1 2 3 4
5 6
7 8 9 10
---------------------
Exhaust Manifold
or different ?

No manual Stuart
January 2010

Hi Stuart, the initial torque is 25Nm, then +60deg, then +60deg, then +60deg, then finally +10deg, the cam sprocket/gear 67Nm, cam carrier/cap 16Nm, cam cover 10Nm the sequnce for the head bolts is as looking down on engine
8, 4, 1, 5, 9
7, 3, 2, 6, 10
you do not need new bolts

nigel
January 2008