How can I replace the brushes for wf02467GB?

Turn machine onto it's side, you will see the motor at the left hand side at the back.(the bottom is open). remove the tyrap holding the cables to the motor casing. Remove the mulipole plug from the end of the motor housing. Using a 10mm spanner remove the two bolts at the belt side of the motor casing then slide the motor to the left off the mounting pins. Remove the brushes from the holders by wiggling the brush terminal after removing the cable. Fit new brushes by feeding the brush spring into the holder then clip terminal back into position. reverse the dismantling procedure to refit the motor.

Steve A.C.
September 2008