I have a Maytag Dryer (Model LDE8424ACE). Recently, the dryer was pulled and pushed back in place with its exhausted pipe twisted. The dryer ran with a cloths load and stopped unfinished. Now, it will not start only hum when the start button is pushed. Do you have a recommended trouble-shooting guide and/or solution?
Sounds like you have a bad start winding on the motor. With the exhaust vent blocked it would have had a poor airflow which could raise the temperature in the cabinet and overheat the motor. This in turn could cause a winding to fail especially on an older dryer. You will need to get the motor tested & replaced if it is faulty.
Lincoln Appliance NZ
September 2008
Automatic Answer
While you wait for answers, we may have found some information which could help you.
howtomendit.com for free repair help, information and advice.
