Replacing the Thetford C2 pump?

Drain off the flushing tank into a bucket. LIft out the toilet roll holder using a pair of grips. Directly underneath you will see a plastic tube and a rubber enclosed electric cable coming from the pump. A small phillips head screw holds the pump housing. Use a magnetic screw driver and take it out. The pump will then lift out as there is plenty of slack in the tube and cable to allow this. A flash light may be needed to see everything more clearly. Before you cut the electric cable I advise you to first check the switch as refitting electrics inside liquid tanks is no job for the novice. If you suspect the pump you would be advised to buy one compete with cable so you can connect back to the switch. Your problem is either pump or switch.

Eric Smethurst
February 2009

I will also be interesting to know

Richard
December 2008

Send email to robertwhiting76@hotmail.com
and I'll send you an exploded veiw of c2 and instructions on what to do.

Bob
October 2008