timming belt?

this method works for most machines with a single cam only twin cam needs more brain cells used up

try to identify #1 cyl
put #1 cyl on TDC
turn cam shaft around so that it rocks on overlap
you may have to turn crank around a bit to facilitate this!
between inlet valve open and exhaust valves closing then turn the crank around one full turn, the cam will turn half a revolution, are there any timing marks or notches lining up with machined faces on cyl head?


sorry if this is not relevant to your machine.

if you are not 100% sure do not under any circumstances start your machine

and a good thing to do these days with the proliferation of digital cameras it to take photos of anything b4 you pull it apart!

jkwobble brisbane
October 2008

on what??????

anon
October 2008