12hp Briggs engine?

Good for you!
If you have any trouble getting it dialed in just post again.
I'm between mower and snow blower repair seasons here,
so I'm checking these forums almost daily.

Rick
November 2005

Hey Rick , I found a engine just like mine with the bearing spun on the bottom, used my bottom casing and now have it mounted on mower. Just ran it for a few minutes and it didn't leak. I might have something . Thanks again gerard

gerard
November 2005

I'm assuming your engine is a 12HP I/C
You can buy a new short block that the parts you salvaged
will bolt on to, but their not cheep. You may be better off
to look or a used engine. I've seen a few on ebay, but
beware of shipping costs before bidding.

Rick
November 2005

Rick, I took the engine apart, you were right,it had a busted rod bearing,saved the starter,carb,magneto,muffler casing was cracked. Thanks for the help

gerard goldey
November 2005

Don't turn that engine any more. If it's a broken rod you can do major damage by turning it. Most often I find the oil slinger off the bottom of the connecting rod has come loose. At any rate anything loose in an engine usually means a rebuild. But first you'd need to check to be sure the block is not cracked anywhere. If it is the engine is junk.

Rick
October 2005