Simpson Encore 806...showing DF on sreen?

Hello we had a power cut my simpson encore 806 will not turn on and does not show any lights indicating its on .. have tried other appliances on the switch connection and all go please assist

Miriam0112
March 2018

My 806 washer, filled up with water just a little, then started to beep, the DF came on the screen, the machine would just stop, and not work at all.. I checked the temperature sensor.. replaced it.. and it did it again, Im thinking its either a door fault or a drain fault

Molly
June 2015

DF means the temperature sensor is faulty. Replace it. Get a new one from your Simpson agent. Turn power off. Open panel by removing the 3 screws at the rear of panel & swing it up. If you are standing behind the machine look on the left hand side at the top of the circuit board. You will see a small white plug with 3 wires (red-white-black) Very carefully pull this plug toward you off the 3 pin base. The other end is the sensor pushed into the water inlet chamber. Pull it out. Push new sensor into water chamber (make sure black rubber o-ring is on it) Push wiring plug back onto 3 pin base. It can only go on one way. Do not force it or twist it as the 3 pins can be easily broken or damaged. Then close panel & power up.

Lincoln Appliance NZ
January 2009