due to a power faliure i replaced a dud battery on my veritas 8 alarm since following the intruction from a question i found on this site i have replaced the battery using reset 4321 but i cannot arm the alarm now and the tamper led and unset led are both lit when we type in 4321we have to hit full but the alarm just bleeps and does not arm any help is greatly appreciated
Downpower system battery and mains , power back up within 10 seconds press rest button panel should default . Use code 1234 Engineer 4321 however panel can be locked by previous engineer in which case you will require his/her code before reattempting. Hope this helps.
Ian
January 2009
the user code does nothin either we tried it just bleeps and does not arm and the tamper and unset led r still on
ste
January 2009
That code is the default Engineer Code, it will not set/turn on the alarm.
The User Code sets/turns on the alarm.
acorn
January 2009
Automatic Answer
We may have found other answers which could help you.
howtomendit.com for free repair help, information and advice.
