kenmore washer?

Put coupler assembly in a warm glass of water. Unscrew two screws from lower part of main control center. Lift up and tilt back control panel. Use slotted screwdriver to undo metal clasps. Disconnect wire harness that goes through shell. Shell comes up and out from top back. Underneath remove two clips holding water pump and pull this off. Then unscrew two screws (top and bottom) from holding clips on motor. Pull this out and you will see the coupler assembly. Remove old and put in new. Be careful not to break it! Warm water helps the installation. You will need to lightly tap the plastic pieces onto metal.
12/07/05

Jeff
December 2005