error code ?

drier temp. too high - check fan motor, temperature sensor or restricted airflow.
Most likely a blown heater element in the drier unit. Power off, drag machine out onto the floor, remove back cover and top cover. Check the fan in the drier unit - if its not rotating, the element will have overheated and possibly triggered a thermal cutout device which cuts off the power to the heater element. Some thermal cutouts can be reset, most need replacing. Only way to test is to disconnect the wiring and take resistance readings across the element and any thermal cutout device with a multimeter. Check all wires and connectors generally for internal breakages - caused by movement of the wiring loom attached to the drum. Over a long period of time the wire strands inside the insulator break through metal fatigue. Although the outside of the wire appears ok the internal is open circuit. Pull on each individual wire - if theyre ok internally, they shouldnt stretch. Washer Dryers work by having cold water trickle down the inside of the drum whilst hot air is being blown into it.The hot moist air from the washing converts back into liquid when it hits the cold water, and it is pumped out along with any fluff that may be with it. Unfortunately the internal ducts and channels get congested because of this fluff and prevent the cycle being completed. The condenser needs to be removed and cleaned out thoroughly and so does the sump and outlet hose.

Repair and service your own washing machine. Go to www.2ndwave.co.uk/manual.html

dannyboy
February 2009