Mend > Vans

brake pads to a citreon saxo 1.1?

one pad has worn down to the limit on my saxo. I am unable to fit a new pad betwen the disc and the outer flat face of the calliper.

What do I need to do to fit the new larger pad ? - do I need to remove tha calliper ?

the one nearest the piston easily fits by pushing back the piston.

mfleet56
July 2009

Citroen Citroen Saxo 1.1 Vehicles, Vans

Many thanks - where exactly are the sliding pins located and what diameter are they?

mfleet56
July 2009

The caliper is mounted on a sliding pin system it should enable the caliper to slide so that the pads wear evenly, it sounds like your caliper has seized on the pins, you will need to free them off with WD40 or similar (avoiding getting any on the disc's!!!) then when they are free coat them in copperslip anti-seize paste

nigel
July 2009

the front brakes on a saxo are a single piston sliding caliper design,

the sliding caliper has seized up due to dust/rust give it a lever with a old screwdriver or flat bar till it slides easily by hand, may need to strip down clean and re-grease the slide pins check if rubbers gaiters are split on the caliper slides

wirecutterman
July 2009