My NSM Prestige 160 jukebox carriage ?

email me for the manual and service programme

phil
September 2010

You may wish to test the function of capacitor c9 10 uf 150 volt, and resistor r 68 within the control centre. Myself I believe it is the reversing switch. A simple test. Multi meter set on buzz/ohms. remove white 9 pin plug 4b
test between pin 7 and 3 operate the reversing lever a buzz or full scale reading should be obtained in one of its position. Now test between pin 7 and 4 again operate the reversing lever, a buzz or full scale reading should be obtained. The operating lever being the lever the carriage hits.

Ray Taylor
February 2010

Could you be a bit more specific. Does the motor continue to run ? The only bit of electronics is the changing of polarity of the motor windings controlled by the reversing switches situated on the back of the magazine(left side)
Try this link, to be continued by myself
http://en.wikipedia.org/wiki/Jukebox

Ray Taylor
February 2010

hi there
i had this problem and sorted it easy
but can not remember what i did
will get back to you soon

colin
September 2009