I have an old ADT Safewatch Pro 2000 Home security system. My back-up battery was low and system kept chiming so I pulled the plug when I went away for 2 wks. I have now replaced the battery. When I plug it in and attach battery the system comes up but then goes into a mode which signal reads "Busy Standby E4" How do I reset?
According to my owner's manual for the Safewatch Pro 2000, it says that if a Busy-Standby message is displayed for more than 1 minute, the system is disabled and you should call for service immediately.
Shari
October 2009
Automatic Answer
We may have found other answers which could help you.
howtomendit.com for free repair help, information and advice.
