fault code indesit?

After checking all the hoses and removing a 5p coin from the filter, I checked the valves and in the end removed the PCB (Look up from underneath, it's in the white plastic shielding where all the wires go). I found there was a short on 2 of the tracks. I removed the short by scraping between the tracks and then soldered a piece of wire to the 2 points that should have been connected and :- hey presto it works again.

Si
May 2006

ta will give it ago

charlie fordham
April 2006

I've got a similar problem on a wd12. I have been told to clean the filter (found behind the front kicking plate) and check the water inlets (both hot and cold) because 10 flashes on mine relates to a pressure problem. I am now going home to check my hoses aren't kinked. Good luck.

si
April 2006