Recent: How change tax rate Sanyo ecr 360?

Mend General D.I.Y

Mend D.I.Y, General D.I.Y
Find out how to mend it for free.
Ask Question
Mend D.I.Y, General D.I.Y
Find out how to mend general d.i.y

Mend general d.i.y ...

Mend D.I.Y, General D.I.Y

Minimix150 turns clockwise?

I have a Belle minimix 150 cement mixer, bought second hand, it need capacitor changed and then worked but dru... [Read more]
Mend henderson garage door
2

Safety light flashing?

henderson sprint s550n garage door opener safety light flashing what is wrong?
Mend model battery mains

How can I mend my model?

I have a Uni-Com Model 11575 bell push. I replaced the battery and when I went to turn the mains off and on a... [Read more]
Mend working wire pull
3

Door bell not working?

i have a uni-com door bell,i turn the electric off to wire in a shower pull switch when i turn the electric ba... [Read more]
Mend garage stays time

Garage opener not working?

Lift Boy GB1. Courtesy light stays on (doesn’t time out) & the door does not react to opening or closing. Re... [Read more]
Mend General D.I.Y

Mend > General D.I.Y

Mend Kitchen Mixer Tap

How to mend a Kitchen Mixer Tap ?

My kitchen mixer tap sticks when I use the hot water, it screeches and will only move up down left & right with great difficulty. When it cools down, i.e when I dont use it for a bit, it is ok, still a little stiff but not nearly as bad as after using the hot water. What can I do, do I need to replace the washers or discs or whatever? It's 2 years old, doesn't get too much wear.

Pete
December 2010
D.I.Y, General D.I.YKitchen Mixer Tap
Hello Brian, thanks for taking the time to respond. Yes it is a lever type tap. there is central disc, it is a single lever which goes right for cold, left for hot, centre for mixer, up and down to control the flow. Is your solution still relevant? Thanks again.

Pete
December 2010
i presume it's not a lever action so remove tap head (usually by removing centre disc and removing screw) with spanner or grips remove tap body and gently pull off clip on the splined shaft remove and clean all the parts and apply good quality grease when you screw the body back in make sure the tap is in the fully open position

brian
December 2010

Automatic Answer

We may have found other answers which could help you.

Click here for Kitchen Mixer Tap
Mend D.I.Y, General D.I.Y
Find out how to mend general d.i.y
Mend dripping flow overflow

How do I mend a dripping over flow?
Mend foot pedal kenmore

Where can I buy an electronic foot pedal or a rheostat foot pedal ?
Mend make batteries phone

How to make a portable charger out of batteries for an android phone ?
Mend D.I.Y, General D.I.Y

how do i mend split outer hose on bosch ptl1 wallpaper stripper?
Mend D.I.Y, General D.I.Y

is the yacht varnish fireproof?
Mend radio signal model

Door chime radio signal detection on the smartphone?
Mend henderson garage door

Safety light flashing?
Mend change buttons code

How to change chime on Unicom 62097?
Mend lock handle side

'Slipped' yale lock?
Mend working wire pull

Door bell not working?
Mend wont switch off

Electric kettle won't switch off?
Mend D.I.Y, General D.I.Y

tetra elec fault?

How to mend ...

Find out how to mend just about anything howtomendit.com for free repair help, information and advice.

Related Categories

Mend D.I.Y Tools
D.I.Y Tools
Mend Decorating
Decorating
Mend Gardening
Gardening
Mend Lighting
Lighting
Mend Plumbing
Plumbing
Mend Roofing
Roofing
Mend Switches and Sockets
Switches and Sockets
Mend Toilets
Toilets
Mend Windows and Doors
Windows and Doors

Mend D.I.Y, General D.I.Y
Find out how to mend general d.i.y

Related searches...

boiler combi heatingboiler combi worcesterWorcester Bosch HeatingWorcester Combi Heatingsewing machine singer