How do I fix my Fisher Paykel GWL11?

Remove hoses & open panel with power off. Remove 2 screws at rear holding valve bracket & remove the bracket. If your model has 2 seperate valves then remove screw holding water chamber and pull chamber up & out. Remove valve from chamber & instal new one. Make sure you swap rubber seal from old one to new one first. If your model has a one piece double valve. Then do the same only there is no water chamber to worry about. Put hoses back on & run machine for a minute on fill. Stop machine & check inside panel that there is no leaks.

Lincoln Appliance NZ
December 2011