My Optima 65 GBC laminator control panel is not working?

Hi I service roll laminators all over the pittsburgh area. so you power the machine on but nothing happens?

Most likely you have a interlock switch not set, or a circuit breaker tripped.

first make certain the top clear cover is shut, and the feed tray installed and the pin sticking out of the front of the feed tray is to the left.

but also check the breaker, its on the rear left side, and comes out the bottom. try pushing it in. you can roll the machine on ts back to access the breaker. its near the power switch but sticks out the bottom of the machine. the breakers go bad and false trip.

if these dont help feel free to give me a call, its free

bob haller service and sales pittsburgh pa 412 366 4906
March 2012