Mend > Home Alarm Systems

4

How to change alarm code?

I have lost the instruction manual for my house alarm Melcom ST6100 and I need to change the alarm code can an... [Read more]

1

Das alrm system?

I noticed the power on light on the keypad was not lit up. The pad would not operate and I dont seem to be abl... [Read more]

1

alarm wont set?

the alarm wont set when entering the code it made a dull beep and wont set

Sensor Replacement or Removal in a Safewatch Plus RF?

I have an ADT "Safewatch Plus RF" alarm system and one of my "Sensor 9" module has gone wonky. Is there any p... [Read more]

2

How can I stop the bell from sounding on entry?

I have a Accenta 8 home alarm system and whenever I fully arm the system I have 30seconds to leave the house, ... [Read more]

2

alarm keep bleeping?

All of a suddend my veritas 8 alarm keeps bleeping. i have tried setting it and resetting it but this has not... [Read more]

1

Forgot Code Unset light Flashes?

Please can anybody help, i turned off electricity for 15 min to fix a light then alarm went off i tried to p[u... [Read more]

1

how do i fix my veritas alarm?

I HAD A VERITAS ALARM PUT IN JUST OVER A YEAR AGO. ON EXACTLY A YEAR SINCE IT WAS FITTED, WHEN UNSET THE SENS... [Read more]

1

fitted new battery what next for scantronic 9427 panel 9448?

alarm was going off all day battery went flat and would not recharge, I have replaced the battery and the box ... [Read more]

optima alarm doesnt go off when it should?

We have fitted an optima gen4 alarm and although it looks as if it is working it doesnt go off when it is prim... [Read more]

3

Cant change the code on my veritas 8 panel!!?

Hi all, I'm having problems changing the code on my veritas 8 alarm system. At the moment the code is 4321 ... [Read more]

1

How Can I Fix a Gardtec 360/580 Alarm System?

I have recently moved into a new house which has an alarm fitted. The previous owner left me a manual for a Ga... [Read more]

1

need a manual?

one of the number on the pad has stuck Ineed a nanu al as I have lost mine where do I get one from veritas ... [Read more]

how to fix my 'equalizer 3' burglar alarm?

we recently moved, and replaced the floors, when fitting we noticed an old frayed wire anat was broken, connec... [Read more]

1

how do i fix our alarm?

we recently moved, and replaced the floors, when fitting we noticed an old frayed wire anat was broken, connec... [Read more]

How do you get rid of AP Aux power failure after pressing 99 from engineer?

How do you get rid of AP Aux power failure after pressing 99 from engineer function, trying to reset the syste... [Read more]

1

accidently nicked one of the cables?

accidently nicked one of the cables, every time I set the alarm it goes off with the tamper setting on the box... [Read more]

1

Change Pin Code for Scantronic 9752?

We wish to change security code on the above alarm system Scantronic 9752

7

Accenta alarm - tamper light permanently on, will not reset?

Recently knocked the wall down between my dining room and living room and there was a PIR in each room. had to... [Read more]

1

Veritas 8C?

I want to change my code, buttons are now sticking on old code have tried "enter existing code, Press Prog, P... [Read more]