Mend > Home Alarm Systems

what wires are fitted to an optima xm alarm?

Each time i set the alarm it activates. i have taken fuse out and opened box. i think the wires from 19 have c... [Read more]

1

Wiring up a Scantronic 9427 Style?

I had to move my keypad, a Scantronic 9427 Style, and didn't make a note of which colour wires from the 9448+... [Read more]

1

Whats it the problem with my veritas R8?

when i turn on the lights in the house the panel activates a tamper fault on zone 3 & 4. This isnt everytime b... [Read more]

2

green light flashing?

i tried turning the alarm off at mains but the green light hasnt stopped flashing

veritas 8 alarm?

I recently changed the battery on my alarm, however the red tamper light is permanently on and I cannot set th... [Read more]

can it be fixed or does something need changing?

I have a Scantronic 9200 that seems to have a problem. when the alarm is triggered it contines to sound for ho... [Read more]

my eurosec system just wont work?

i have six terminals in my control panel strobe+ strobe- bell hold- sabtmp bell+ and bell- but only 5 terminal... [Read more]

How do I change the keypad battery on a Gardtec 360/580?

The battery on my Gardtec 360/580 keypad needs replacing but I can't work out how to open the cover. There is ... [Read more]

1

Home Alarm Systems?

My Optima Compact worked fine until yesterday until the electricity was switched off for an hour or so. When i... [Read more]

1

power light flashing veritas 8?

the problem is i canot set the system as the power light is flashing all the time . i have switched it on and ... [Read more]

1

How can I fix my Scantronic 500r alarm?

How do I change the batteries in the PIR detectors.

1

I have bought myself a scantronic 9751 ?

I dont understand how to connect a standard 6 wire cable from a detector to it

1

I need instructions ?

Ineed instructions for micromark mm23244 as can not install without them lost mine and just moved

1

My bell will not sound and trouble light with the # 3?

When I check system trouble (function 4) #3 lights up and beeps. The manual says #3 is wireless receiver trou... [Read more]

Where on panel of 9800 is the enter key?

I need to change alarm code -The 9448+ manual which is the only one I have states press 6 then enter followe... [Read more]

2

Where on panel of 9448+ is the enter key?

I need to change alarm code - manual states press 6 then enter followed by existing code then new code. I c... [Read more]

1

Update - XM6 Alarm Panel Not Responding?

Hi again.... further to my previous post... Having dismantled the panel, I have found a burned out resistor o... [Read more]

1

Veritas R8 wont set as saying zone 3 open but its not?

My veritas R8 panel is saying that zone 3 is open when I try to do a full set of the alarm even though the doo... [Read more]

how can i find out the auxilary code for my alarm ?

had a power cut and the alarm has reset itself thus changing the code. its a 24 secure and safe HG-1000 PANEL ... [Read more]

How can i reset my alarm?

I have just moved into a new home with a securitech alarm system which is quite old.My 2 y,o son was messing w... [Read more]