Mend > Home Alarm Systems

1

resesting after battery failure?

hi john have just replaced battery on my veritas alarm. the red tamper is still on and the alarm wont finish... [Read more]

8

Anyone know where I can get replacement Scantronic 9800 control panel?

My control panel digits are really hard to push now after 16 years. Banham have told me that I need to replace... [Read more]

vertias c8 alarm?

My vertias c8 alarm will not eccept my code and keeps going off any advise please

2

the green unset button on my alarm keeps flashing?

can anyone help me to find out how i can reset my alarm?

11

Optima 2 Plus tamper light - unable to reset from remote panel?

I have searched this site for an answer and apologise if I upset anyone by asking a stupid question! This hap... [Read more]

2

Micromark MM40051 factory/reset code?

The system is around 10 years old not used for 8 years now install on our summerhouse, powers up but unable to... [Read more]

1

no power to key pad ?

I have a veritas R8 the one with no digital Display it has lost all power to the key pad no lights so am unabl... [Read more]

2

how to find installer code?

how to find installer code

4

How to remove the tamper light?

Hi There I've just purchased my 1st property and the alarm won't set,a neighbour who looked at it ... [Read more]

22

Wires cut to sensors - rejoined but sensors still dead?

A carpet fitter cut through all the wires to the three sensors for my Optima XM alarm. We rejoined the wires, ... [Read more]

4

premia 9 alarm showing code 11?

hi i have premia 9 alarm and had power cut since then showing code 11 and nothing works can anyone help th... [Read more]

1

How can I fix myScantronic 9600?

Needed to change 7 amp battery.Now done but now have message Tamper Keypad 00 Tamper on panel

1

how can i fix my veritas 8 alarm??

hey i have a veritas 8 alarm in my house which wont set. when i press the full button the alarm bleeps really ... [Read more]

5

micromark intruder alarm 23244 ?

move in to rented flat it has a alarm but no codes need reset codes please

1

how do you get rid of sr on the key pad ?

how do you get rid of S R on the key pad or can i reset the systems there is no fault !!!

14

battery missing fault?

can anyone tell me how to get rid of a missing battery notice? i have a scantronic 816 control panel with a 91... [Read more]

10

Veritas alarm?

How can we reset our Veritas alarm after a power cut? The display shows 4 red zone lights and a tamper light i... [Read more]

28

veritas 8?

hi iwas wondering if you could help we have the veritas 8 alarm and in this cold weather it is tweeting like a... [Read more]

1

how do i turn off strobe light?

I have an accenta burglar alarmwhich went off over the weekend while we were away;the keyholder cancelled the ... [Read more]

1

Accenta alarm?

Hi, my alarm system on the house just out of the blue went off whilst I was in the house. I input my code to ... [Read more]