Mend > Yachts

2

How can I get a teak oil stain off a fibreglass hull?

I was recently oiling the toe rails of my Jeanneau Su Odyssey 42 DS and I spilt some teak oil on the white fib... [Read more]

jrc mk1 1000 radar?

how to install and conect wiring to boat. just inherited the units with no instructions or instalation diagram... [Read more]

how to fit new window rubbers?

i am wanting to replace old rubber sealed windows with new ones

1

How can I fix a longitudinal crack in the keel of my ply hulled fireball?

I bought a 1980s Fireball dinghy 'as seen' that has clearly suffered a couple of years of rain penetration due... [Read more]

2

How can I remove varnish from my foredeck ?

I have a beautiful Beardsley Cadet which is immaculate apart from the fact that, after lying outdoors for a nu... [Read more]

1

1999 seadoo gtx ?

water in cylanders

1

Any good reference to How To Replace A Rotten Wood floor in an older fibreg?

I have an older fibreglass boat but the plywood floor is carpeted and very rotten. Am looking for a proper How... [Read more]

6

info on hydromarine dm 12 engine?

hi can anybody give some information about the engine that i have it is a hydromarine dm 12hp,but it is actual... [Read more]

mercury mariner 25hp no start?

hi how are you my name is ernesto i have mercury mariner 25hp,its no start because no ground the motor has pow... [Read more]

1

yanmar not cranking?

my yanmar was idling and then the RPM's increased and I shut it off (was concerned it would blow up). I have ... [Read more]

Help Yanmar 20gm cooling system blocked?

Is there any type of cleaning agent that can clean the insides of the engine block of a saltwater cooling syst... [Read more]

2

do new planks for a boat have to be killen dried?

hi can any one help, need to know if new planks for a 30foot doublender clinkerboat need to be killen dried .t... [Read more]

1

yanmar 20gm cooling system?

water flow coming out of engine reduced.checked impeller seems correct. water intake clear.what else can i che... [Read more]

I have a 1963 Owens 30ft and need to repair the bottom planks?

I have one plank that has pushed out...maybe to stiff a caulk? How do it push it back into place??? Randy

1

Repairs to gunale & blunt end bow, small crack !?

Hi, my dad was a professional boat builder, he built me a blunt end dinghy (excuse me if not using right term)... [Read more]

1

boats?

i have a mercury 25 outboard engine,it has 2 spark plugs.2 boatmen have looked at it,and are not certain?if it... [Read more]

2

repair small hole in marine ply hull?

I have been given a marine ply hulled Enterprise. There is a small hole in the side near the bow. How can I b... [Read more]

HOW do i disconnect the shifter linkage on a 25 hp mariner to change the wa?

shifter linkage removeable on water pump on 25 hp mariner

3

On a clinker built boat what is the first plank called?

On a clinker built boat what is the first plank called

1

Swordfishdinghy repair?

How do I refit the transom to a Swordfish dinghy. The veneer laminate of the hull needs to be fixed to the tra... [Read more]