Mend > Washing Machines

1

how to fix my whirlpool washer if something is lost inside machine?

I lost a knee high nylon inside my whirlpool washer model #LSN1000JQ0 it can run as long as the load is small.... [Read more]

1

How do I remove the door seal on my Hoover H130E?

I have a wire from an underwire bra in the space between the inner and outer drums and need to know how to rem... [Read more]

2

How do replace the on/off switch on my Bosch WFB2005 washing Machine?

Hi, The on/off button has become stuck on my washing machine and so wont turn on. Ive ordered a replacement... [Read more]

2

How can I change the door seal?

Zanussi FL1085 is leaking from the front of the machine. I assume it is the door seal. Is the seal available a... [Read more]

3

AEG oko-lavamat 76630?

hi , i have AEG oko-lavamat 76630 , i want to know what about error E40 , help me plz , Email:mrad_6@hotmail.c... [Read more]

1

zanusi wdt 1085 trips house rcd?

on start up my zanusi wdt1085 trips the main rcd. its about 6 years old so would it be the motor brushes groun... [Read more]

1

HOW TO REMOVE OR OPEN THE FRONT CONTROL PANEL ON HOOVER PERFORMANCE 1100 AC?

HOW TO REMOVE OR OPEN THE FRONT CONTROL PANEL ON HOOVER PERFORMANCE 1100 AC 110

1

water is leaking from the drum i think?

i have a wd64 hotpoint washing machine and water is leaking from bottom of the machine. I think the drum is le... [Read more]

1

I NEED A RUBBER FOR A ZANUSSI (FS1255W)?

I HAVE A ZANUSSI MACHUNE THE RUBBER HAS A HOLE IN THE FRONT. I WOULD LIKE TO NO HOW MUCH A RUBBER COST AND WH... [Read more]

3

My LG Intellowasher 7kg WM-1171 FHB dispalys error code "SE"?

My LG Intellowasher 7kg WM-1171 FHB, only runs for about 30 seconds cuts out and then displays the error code ... [Read more]

1

how to fix model 110.23012102 type111 cp1913371?

How do i remove the water softner cap to clean it can it be lifted or twisted off. Also can the agitator be li... [Read more]

1

where is the filter on my hotpoint WF865A?

I need to empty my filter and I don't know where it is I was told it is at the back but can't seem to find it.... [Read more]

1

fault?

f-05 is appearing on the lcd screen have no manuall,this is a fault can anyone help,also i have just plumbed i... [Read more]

1

the rubber on the filter has come out of place and I dont know where i shou?

I took the filter out to clean it as washing machine was not spinning properly. After cleaning the muck off it... [Read more]

1

How do i change ball bearings in my zanussi IZ jetsystem?

HI I have a 5 year old zanussi IZ jetsystem,it is starting to get a bit loud when it spins and the drum doesn... [Read more]

1

how to rplace bearings and seals hotpoint WMA10?

looking for manual to show details of how to replace bearings and seals on hot point WMA10 washing machine

1

BOSCH WWF 2001 Washing Machine?

Hi I have a Bosch WWF 2001 Washing Machine and i need to replace the brushes. Can this be done with motor sti... [Read more]

2

HI I HAVE A BOSCH WFK 2801 AND IT IS STOPPING AT 3 MINS WITH A FEW LIGHTS?

FLASHING I HAVE CLEANED THE PUMP OUT BUT IT IS STILL DOING IT ANY IDEAS ?

1

water problem LGwd(m)14316fd?

new washer plumbed in ok when not in use it slowly fills with water up to the rubber seal this takes about eig... [Read more]

2

how can i fix my indesit wia111?

my washer stops half way through wash cycle when it should be about to start spinning.it has to be emptied of ... [Read more]