How to mend ... Old Kenwood Mixer

remove top cover?

How to remove top cover from Kenwood A901 mixer have removed 3 screws from rear for blender attatchment a... [Read more]

Kenwood Chef Mixer?

How/where can I dispose of my unwanted Kenwood Chef Mixer Model 701A? It belonged to my mother-in-law and I ha... [Read more]

how can I replace or mend the coupling housing on Kenwood Chef mixer?

The coupling housing on my Kenwood Chef A710A mixer has split and all of the spare parts websites say that the... [Read more]

I think I have killed my Kenwood!? Kenwood mixer 10 years old?

I decided to use my Kenwood - nearly 30 years old and wonderful for everything, to make bread dough. The poor ... [Read more]

Kenwood KM 200 mixer how to remove the plastic cover?

I want to give our Kenwood KM 200 mixer a good clean. After removing the outlet covers and the three screws it... [Read more]

How do I strip a Kenwood Model KM210 Mixer?

How do I strip a Kenwood Mixer model KM210?

KMXC560 how to replace small pully & tension bar?

I have to replace the small pully and tension pin on my Kenwood Chef KMC560 I tried to use the liquidiser when... [Read more]

im trying to fix a kenwood chef mixer a703c ,motor goes gearbox seems to wo?

i have the kenwood a703c the dog clutch doesnt seem to wind right down on top of the large plastic gear .

I have smoke coming out of kenwood a902 chef excel?

I have a kenwood a902 chef excel mixer and was using it and smoke was coming out of the motor housing it is ab... [Read more]

How to reassemble case on Kenwood A177 handheld mixer?

Cannot work out how to reassemble case on my Kenwood A177 handheld mixer. The sliding switch does not to line ... [Read more]

Kenwood FP 476 dismantling?

I need to dismantle my Kenwood FP 476 mixer as the main drive is inoperable. From previous correspondence I no... [Read more]

kenwood mixer smoking?

My Kenwood mixer started to smoke Bradley while mixing,what could it be and how much would it cost to get repa... [Read more]

kenwood chef A701 kitchen mixer?

Motor runs OK speed control works OK, until the motor is put under increased load and it cannot cope, checked ... [Read more]

what to clean gearbox of mixer with?

have a Kenwood chef a901e mixer and I am replacing broken gears. I need to clean housing can I use petrol to d... [Read more]

What do I do with the 6th wire when replacing new motor ?

Kenwood mixer FP520. " speed motors have 5 wires the 3 speed motor has a 6th wire what do I do with the extra ... [Read more]

Kenwood A901P changing speed controller?

Hi Because a capacitor had burnt out on this mixer I purchased a replacement speed controller board from espa... [Read more]

How to fix speed control circuit on a kenwood chef A.901?

Kenwood Chef Mixer Model A.901 The mixer stopped when a capacitor blew-up. I obtained the Kenwood repair k... [Read more]

How can I open top part of a Kenwood MX270 mixer?

I need to change speed controller of my MX270 mixer because speed is inconsistent while working. How can I se... [Read more]

can you supply a spare parts list for the Kenwood 701A Mixer?

can you supply a spare parts list for the Kenwood 701A mixer

How can I fix my Kenwood "Chef Excel" (electronic) KM210 Ser No. 0389684 ?

I have noticed a small amount of oil at the rear of the mixer. Not knowing what to expect as yet I have not a... [Read more]