Office Appliances, Document Laminators

Our GBC laminator ultima 65 heats but does not roll forward? Suggestions?

Our laminator heats up but will not engage and roll forward to feed laminator film through. Any suggestions?

How to fix my laminator, never used but just beeps at me?

Hello I got this laminator Voyager A3 High-Performance Office Laminator by Fellowes. Had it sitting on a f... [Read more]

laminator is not heating up?

I have GBC Ultima 65 laminator, all appears to be working fine except heat light is blinking all the time and ... [Read more]

Film rolling up on rear rollers?

we have ultima 65 laminating machine cleaned all rollers bur rear gray rollers the film keeps wrapping around ... [Read more]

removing laminating sheets on rollers when it was replaced incorrectly?

I mistakenly misfed the top roll and the sheet is stuck to the roller. Most of it has come off but there is a... [Read more]

How can I tighten film tension?

I have a GBC 173LM. The film tension is very loose. How can the film tension be adjusted.

Ultima 65 isn't heating up?

The power light comes on and the rollers will move but it isn't heating up. The heat indicator light doesn't c... [Read more]

GBC Catena 65 is getting too hot?

GBC Catena 65 is getting too hot. Not a lot, but enough to wrinkle/wavy/orange peel the lamination. The temp i... [Read more]

how can i fix my fellowes laminator?

My laminator is showing standby light only so how can i fix it so that it can show green light

J-H Card/Guard 6200?

Can anyone tell me how to get the rollers out to clean them? I found instructions for a similar model but the ... [Read more]

Pouch stuck in Fellowes Mars A4 laminator?

An a4 pouch has become stuck inside the laminator and i am unable to get it out as not visible. Only 2 screws ... [Read more]

How can I fix my Rexel LV250HS - no power light?

Hi, I need to fix a Rexel LV250HS laminator. Rollers are moving but there is no Red power light showing or... [Read more]

how can I fix Laminator RT-A4 Not switchng ON?

My Laminator RT-A4 not able to switch

help getting a wrinkled thick paper jam out of the exit rollers?

Teachers were trying to laminate new symbols for the classroom and the paper rolled up behind the back roller... [Read more]

GBC 4250, runs backward with mode select switch in off?

When operating the machine and putting the mode select switch in the off position, the rolls turn backward ins... [Read more]

Model GBC 4250 laminator drive chain is loose?

How do I adjust the drive chain on our GBC 4250 laminator? I have replaced the two gears and the chain. Ther... [Read more]

How do you reverse motor on Fellowes Mars A3 laminator?

I had a jam in my Fellowes Mars A3 laminator and whilst jammed the machine reversed direction and fed the lami... [Read more]

spares for fellowes Mars A4 laminator?

one of the two drive cogs is broke where can i purchase them

how can i fixfellowes laminator?

Fellows laminator Jupiter 125 does not get hot enough to laminate. Ready light does not stop flashing.

help to un jam card from my rexel lm 35 laminator?

I have a Rexel LM 35 machine I have card jammed in it and I can't get it out help!!