The water heater on the dishwasher is not working. The temperature sensor is OK, the heater itself is OK. Rinses Hold cycle is OK. Washes OK but no hot water or drying.
Mega thanks . My PCB was burnt around the relay pin. I soldered on a piece of wire - now all working
ian, Lancaster
September 2012
great...worked a treat....dry joint on relay..many thanks..saved me a fortune....
les
November 2008
Excellent answer. My machine had the exact same problem and this fixed it. Thanks CK.
Nige
September 2008
Superb that worked. Top Man!
Phil
July 2008
take the pcb out of the fascia panel (where the buttons are that you press to select programs).mark the connections and then remove them all.open up the plastic housing and you will find a relay (inch rectangular bit.might be black or blue in colour???).check pcb tracks and bad solder joints on relay as this is the usual failing point.repair tracks with 15a fuse wire and solder them into place
howtomendit.com for free repair help, information and advice.
Try fixfault.com to fix dishwashers.