iveco daily brakes?

Yes it was the load sensor - pushed up linkage and got fluid to the brakes - bled system and got M O T pass - Many Thanks my friend.

Jimbo
October 2009

not quite sure how they adjust , on some vehicles the adjustment is on link that connects to axle. -if you disconnect link from axle and lift it up towards floor [simulating full load]do you get any fluid to calliper -if so its possibly adjustment,-if still no fluid then valve must be siezed. hope this is of help to you.

k
October 2009

Thanks - you might be right - Theres no fluid getting to either rear caliper - Cracked a bolt on top of the valve with engine running and pedal wedged down - fluid flowed out but still none at calipers - took rubber boot off and cleaned corrosion inside but dont know how to adjust valve - suppose its the bolt in the middle of the valve body? Do you know if they can be unseized as new ones are an arm and a leg - will have another go at it tomorrow - dont want to be defeated and too skint to get the garage to do it - any further advice greately appreciated.

Many thanks

Jimbo
October 2009

have you checked load sensing valve,it may be siezed or want adjusting to give more pressure to rear foot brake.

k
October 2009