feeding an overlocker?

thank, I've tried these suggestions to no avail. There is a screw underneath, near the feeders which comes out but the casing doesn't move. I'm pretty sure it's just that the fedders need raised but can't work out how to do this? Thanks for your suggestions!

PM
December 2009

Hi PM, your problem may be just dirt clogging the feeder. Take off the needle plate and check there is no dirt inbetween the rows of teeth on the feeder. If this is cleen make sure the screws on the feeder have`nt come loose. when you have checked all that and replaced the needle plate wind the machine over by hand with the presser foot down on the needleplate the feeder should lift the foot. If it does and still dose`nt feed you need more pressure on the foot bar. (hope this helps)

Silversurfer.
December 2009

You need enough pressure on the foot so you cannot pull the material with the teeth up, turn the balance wheel so the teeth come up and make sure they are just above the needle plate, if they are below the plate then you can undjust the screw underneath the machine near the teeth to raise them.

drivewithken
November 2009